How To Use MirCrystal

Simple to Apply

Wearing MirCrystal for the first time is easy.

Decide where you want to wear your jewel and clean the skin with water, and dry completely. Q-voe Tip: Do not clean with rubbing alcohol.
Grab your Fine Point Hook Tip Tweezers and lift the jewel off of the clear release liner.
Apply the Jewel to the skin. To avoid lifting be careful not to place anywhere with a lot of bend or natural stretch such as elbows or knees. Q-voe Tip: Do not discard your box with the clear release liner because you will need it to store your jewel and keep it from being damaged when you're not wearing it.
You're done. That's right you did it. Now it's time to enjoy the moment, don't forget to take pictures!

Removing a MirCrystal is Completely Painless.

Use your fine point hook tip tweezers to lift and remove from the skin.
Place the jewel back on the clear release liner. Q-voe tip: If there is any glue on the skin use MirCleaner to remove.

Reapplication 2 ways

Apply MirAdhesive before you put it away.

Q-voe Tip: By adding MirAdhesive to the jewel after it has been worn makes for quick application for the next time use.

Place the jewel stone side down on your hand
Use MirAdhesive and paint a thin layer on the back side of the jewel. Adhesive will be white.
When the Adhesive has dried clear, place it back on the clear release liner inside your jewel box.

Apply the glue before you wear it.

Place the jewel stone side down on your hand
Use MirAdhesive and paint a thin layer on the back side of the jewel. Adhesive will be white.
When the Adhesive has dried clear, place it on the skin where you would like to wear and enjoy.